Practice problems
LC resonance practice problems
An inductor and a capacitor together exchange energy back and forth, oscillating at one frequency: their resonant frequency f₀. These ten problems find f₀ from L and C, choose the capacitance or inductance for a frequency, work out how larger component values change it and finish by tuning an AM radio across its band. Type your answer to check it, and open the working whenever you want it.
The method
- Work in henries and farads: 100 µH = 10⁻⁴ H, 220 pF = 2.2 × 10⁻¹⁰ F
- Swap L and C in the second formula to find the inductance for a frequency
- f₀ is proportional to 1 ÷ √(LC): four times L or C halves it, double divides it by 1.41
- At f₀ the reactances are equal: XL = XC = √(L ÷ C)
The problems
Type your answer and tap Check. Every one has the working, step by step.
Problem 1 of 10
What is the resonant frequency of a 10 mH inductor and a 100 nF capacitor, in kilohertz?
Show the working
- Use f₀ = 1 over 2π √(L × C) in henries and farads: L × C = 0.01 × 10⁻⁷ = 10⁻⁹.
- √(10⁻⁹) ≈ 3.162 × 10⁻⁵ s
- f₀ = 1 over 2π × 3.162 × 10⁻⁵ s ≈ 5033 Hz, which is 5.03 kHz.
Answer: 5.03 kHz
Problem 2 of 10
A radio's tank circuit has a 100 µH inductor and a 220 pF capacitor. What is its resonant frequency, in megahertz?
Show the working
- L × C = 10⁻⁴ × 2.2 × 10⁻¹⁰ = 2.2 × 10⁻¹⁴, and its square root is about 1.483 × 10⁻⁷ s.
- f₀ = 1 over 2π × 1.483 × 10⁻⁷ s ≈ 1,073,000 Hz, which is 1.07 MHz: in the AM band.
Answer: 1.07 MHz
Problem 3 of 10
An LC circuit resonates at 8 kHz. You replace the capacitor with one of four times the capacitance. What is the new resonant frequency?
Show the working
- C is under a square root, so f₀ is proportional to 1 over √C.
- Four times the capacitance divides f₀ by √4 = 2: 8 kHz over 2 = 4 kHz
Answer: 4 kHz
Problem 4 of 10
An LC circuit resonates at 10 kHz. You double the inductance and keep the capacitor. What is the new resonant frequency?
Show the working
- f₀ is proportional to 1 over √L, so doubling L divides f₀ by √2 ≈ 1.414.
- f₀ = 10 kHz over 1.414 ≈ 7.07 kHz
Answer: 7.07 kHz
Problem 5 of 10
What capacitance resonates with a 1 mH inductor at 10 kHz? Give it in nanofarads.
Show the working
- Rearrange for C: C = 1 over (2π f)² × L.
- (2π × 10,000)² ≈ 3.948 × 10⁹, and times 0.001 H that's 3.948 × 10⁶.
- C = 1 over 3.948 × 10⁶ ≈ 2.53 × 10⁻⁷ F, which is 253 nF.
Answer: 253 nF
Problem 6 of 10
What inductance resonates with a 47 nF capacitor at 20 kHz? Give it in millihenries.
Show the working
- Rearranged for L, the same form holds with L and C swapped: L = 1 over (2π f)² × C.
- (2π × 20,000)² ≈ 1.579 × 10¹⁰, and times 47 × 10⁻⁹ F that's about 742.
- L = 1 over 742 ≈ 0.00135 H, which is 1.35 mH.
Answer: 1.35 mH
Problem 7 of 10
A 10 mH coil and a 100 nF capacitor are at resonance. What is the reactance of each?
Show the working
- At resonance XL = XC, and both equal √(L over C).
- √(0.01 H over 10⁻⁷ F) = √100,000 ≈ 316 Ω. Check: XL = 2π × 5033 Hz × 0.01 H ≈ 316 Ω.
Answer: 316 Ω
Problem 8 of 10
An AM radio has a 250 µH tuning coil. What capacitance tunes it to a station at 600 kHz, in picofarads?
Show the working
- C = 1 over (2π f)² × L, with f = 600,000 Hz and L = 0.00025 H.
- (2π × 600,000)² ≈ 1.421 × 10¹³, and times 0.00025 H that's about 3.553 × 10⁹.
- C = 1 over 3.553 × 10⁹ ≈ 2.81 × 10⁻¹⁰ F, which is 281 pF.
Answer: 281 pF
Problem 9 of 10
Stretch: that 250 µH coil is tuned by a variable capacitor whose largest value is 365 pF. What is the lowest frequency the radio can tune to, in kilohertz?
Show the working
- The biggest C gives the lowest f₀. L × C = 0.00025 × 365 × 10⁻¹² ≈ 9.125 × 10⁻¹⁴.
- √(9.125 × 10⁻¹⁴) ≈ 3.021 × 10⁻⁷ s
- f₀ = 1 over 2π × 3.021 × 10⁻⁷ s ≈ 526,900 Hz, which is about 527 kHz: just below the bottom of the AM band.
Answer: 527 kHz
Problem 10 of 10
Stretch: a tank with a 100 nF capacitor resonates at 10 kHz. What capacitance must you add in parallel to bring it down to 8 kHz, in nanofarads?
Show the working
- Capacitances in parallel add. f₀ is proportional to 1 over √C, so C must increase by a factor of (10 over 8)² = 1.5625.
- The new total is 100 nF × 1.5625 = 156.25 nF.
- Add 156.25 nF − 100 nF ≈ 56.3 nF. The nearest E12 value, 56 nF, gives about 8.01 kHz.
Answer: 56.3 nF
“LC resonance” is lesson 6 of 6 in Oscillation Coast, Electronics World 4. Free with an account. Lessons unlock in order, so you’ll do the 26 before it first.
Free lesson
Now build it yourself
Each lesson comes in three short parts: see the idea, try it on a live board, then build it yourself, with quick checks as you go.
“LC resonance” is lesson 6 of 6 in Oscillation Coast, Electronics World 4. Free with an account. Lessons unlock in order, so you’ll do the 26 before it first.
Or start from the very first lesson, no account neededCheck it with a calculator
The ideas behind it
- LC resonant frequency explainedAn inductor and a capacitor exchanging energy at one frequency: f₀ = 1 ÷ (2π√(LC)), tanks and tuning.
- How an LC band-pass filter picks one stationAn inductor and a capacitor in the signal's path cancel at one frequency and block the others.
- Q factor and bandwidth: how wide a tuned circuit passesL × C sets where the band sits; R ÷ L sets how wide. Wide enough for the sidebands, no wider.
- Build a crystal radio: tank, diode and earpieceAn antenna, a tuned tank, a diode and an earpiece: a radio powered by the station itself.
Questions people ask
What is the formula for LC resonant frequency?
f₀ = 1 ÷ (2π√(L × C)), with L in henries and C in farads. It's the frequency where the inductive reactance 2πfL equals the capacitive reactance 1 ÷ (2πfC). To find the capacitance for a given frequency, rearrange it: C = 1 ÷ ((2πf)² × L).
Do bigger L and C raise or lower the resonant frequency?
They lower it. Both sit under the square root, so four times either one halves f₀, and doubling one divides f₀ by √2, about 1.41. Doubling both halves it.
What happens at resonance?
The inductive and capacitive reactances are equal and cancel. In a series LC circuit the impedance falls to a minimum, just the circuit's resistance, so the current peaks. In a parallel tank circuit the impedance rises to a maximum instead, which is how a radio selects one station.
More practice
- Ohm's law practice problemsFind V, I or R, then the power, with the working for each.
- Units and prefixes practice problemsConvert mA, kΩ, µF, nF, pF, ms and mV, with the working for each.
- LED resistor practice problemsSize the resistor for one LED or a string, round to a standard value, check the power.
- Electrical power practice problemsPower three ways, energy in kWh, battery life and running costs, all worked.
- Series and parallel resistors practice problemsTotals in series and parallel, mixed networks and branch currents, all worked.
- Kirchhoff's laws practice problemsBalance currents at a junction and voltages round a loop, with the working for each.
- Voltage divider practice problemsFind Vout, pick R2 for a target and work out loading, with the working for each.
- Thevenin and Norton equivalent practice problemsReduce a network to V_th in series with R_th, then load it, with the working.
- Capacitor practice problemsCharge, capacitance, series and parallel, and stored energy, with the working.
- RC time constant practice problemsτ = R × C, the 63% rule, charging and discharging, with the working.
- Inductor practice problemsV = L × ΔI ÷ Δt, stored energy and inductors in series and parallel, with the working.
- RL circuit time constant practice problemsτ = L ÷ R, the current's rise and decay, and inductive kickback, with the working.
- AC voltage and transformer practice problemsPeak, RMS, period, AC power and transformer turns ratios, with the working.
- Capacitive and inductive reactance practice problemsCapacitive and inductive reactance, AC current and impedance, with the working.
- Impedance practice problems for RC and RL circuitsSeries RC and RL impedance, phase angle and current, with the working.
- RC filter practice problemsCutoff frequency, choosing R or C, and the output either side of the cutoff, with the working.
- Decibel practice problemsRatios to dB and back, for power and voltage, gains that add and the −3 dB point.
- Diode practice problemsForward voltage, series resistor current, diodes in series, reverse bias and power dissipation.
- Rectifier and ripple practice problemsPeak output, ripple and the smoothing capacitor for half-wave and bridge rectifiers.
- Zener diode practice problemsSize a Zener regulator's resistor, split its current and check the Zener's power.
- Transistor switch practice problemsBase current, base resistor and load current for a BJT switch, then a MOSFET.
- MOSFET switch practice problemsConduction loss from R_DS(on), gate and pull-down currents, flyback diodes and junction temperature.
- Op-amp gain practice problemsInverting and non-inverting gain, the output, the resistor to pick and when it clips.
- Inverting and summing amplifier practice problemsInverting gain, input resistance, summing amps, averaging, a simple DAC and clipping.
- Schmitt trigger and hysteresis practice problemsHysteresis band, both thresholds and the feedback resistor for a comparator.
- Op-amp limits practice problemsGain-bandwidth, slew rate, output swing and input offset, with the working.
- Binary and hex practice problemsBinary to decimal and back, bits needed, the largest n-bit number and hex.
- Logic gates practice problemsGate outputs, truth-table rows, Boolean expressions and fewer gates, with the working.
- Counters and flip-flops practice problemsTop count, flip-flops needed, frequency division, rollover and ripple delay.
- PWM and duty cycle practice problemsDuty cycle, average voltage, on-time, analogWrite 0–255 and power, with the working.
- ADC and analog input practice problemsanalogRead to volts and back, resolution, dividers and 12-bit ADCs, with the working.